Lite version. The full desktop app adds the 3D stage, the step-by-step setup wizard and the printable setup sheet.Download full version
Moving-Head Control
Not connected
This browser doesn't support Web Serial. Use Chrome or Edge on desktop to connect to the Arduino. You can still preview looks here.
Lost the Arduino. The lights are not under control. Plug the USB cable back in — the app reconnects on its own and puts the look back.
Scenes
Edit scene
Rig
Walks you through the room, what fixtures you have and how they are laid out, then works out every DMX address and prints the list to set on the fixtures themselves.
Room size — metres (width × depth × height)
××
Fixtures spread evenly along the truss until you drag one in the visualiser — from then on they stay wherever you put them. Fixtures on a leg slide up and down it. The room's height is the roof; the truss hangs at its own height below it, and can't be longer than the room is wide. Floor fixtures — foggers, hazers — stand on the deck downstage of it and can be dragged anywhere across it, snapping into line with each other. A fogger can also sit on top of the truss.
Console
Serial link: not connected — click Connect above.
Quick tests
All channels FULL forces every channel to 255 (ignores addressing/colour wheel) — if the fixture still does nothing, it's power, DMX wiring, the shield jumper, or the fixture's mode/address, not the software.
Channel walk
Drive one raw DMX channel to find what it does / confirm the address. Each card on the Rig tab shows the channel range its fixture occupies.
0
Wheel probe — map a colour / gobo wheel
Steps one moving head's colour or gobo channel so you can write down what actually appears. Work up from 0 and note the value where each new colour starts — those readings become the head's wheel table in js/fixture.js.
0
Visualiser
nothing selected — click fixtures to set them by hand